Using the Universal Programming Module 2 (AC162049-2)

In order to connect a device to the Universal Programming Module 2 :

  • Verify the pinout diagram from the device's datasheet.
  • Identify the pin number for each In-Circuit Serial Programming™ (ICSP™) signal (MCLR, all VDD, all VSS, PGD, PGC).
  • Use female-to-female wires to connect the ICSP pins on J3 and J4 to J2 and J8.
​

Note: If the board is being powered externally, the programmer must not be set to provide power. When the programmer supplies power, the J7 jumper must be set to the BOARD VDD position.

The "Universal Programming Module's User's Manual" provides additional information.

  Return to Top

© 2024 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.