Setup MPLAB® REAL ICE™

The MPLAB® REAL ICE™ In-Circuit Emulator is connected to a USB port on your computer and then to the development board. To do so, follow the steps below:

realicesetup.png

1

Connect the USB cable to the emulator.

realiceusb.jpg
Click image to enlarge.

2

Connect the USB cable to a USB port on your computer.

usbblk.jpg
Click image to enlarge.

3

Install the PIC® microcontroller in your development board.

pic16f1937.jpg
Click image to enlarge.

4

Connect the RJ11 cable to the ICE.

realice.jpg
Click image to enlarge.

5

Connect the ICE RJ11 cable to the programming port on your development board.

rj11.jpg
Click image to enlarge.

6

Connect power to your development board.

The REAL ICE cannot power a development board. The board needs to be powered separately.

power.jpg
Click image to enlarge.
© 2024 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.