Configure MPLAB ICD3 for Manual Memory and Range Selection

Normally the ICD3 will control these options automatically for you. If you want to manually control the memories and ranges to program, set Auto select memories and ranges to Manually select memories and ranges as described below.

SelectMemoryRange-ICD.png

1

Open Project Properties window.

2

Select ICD3 node under Categories.

3

Select Memories to Program Option Category.

4

Choose Manually select memories and ranges for Auto select memories and ranges.

At this point, all of the defaults are still in place, but you can change the options that apply to your selected device as shown in the following sections.

  Return to Top

© 2024 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.