Disconnect Tool

To disconnect the programming tool from the MPLAB® IPE, follow the steps below:

1

When the tool is connected to the IPE, all Command buttons including Program, Erase, Read, Verify, and Blank Check are available for you to use. To disconnect the tool, click the Disconnect button next to the Tool drop-down menu. See figure below:

IPE_connect.png

After MPLAB® IPE has disconnected the tool, the Command buttons are no longer available and are grayed out. See figure below:

IPE_disconnect.png
​

Note:
The firmware download will not occur until the connect or disconnect button is clicked, or a programming operation is performed.

  Return to Top

© 2024 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.