Isolator Unit Hardware Setup
Danger_Electrical.jpg exclamation_sm.gifDANGER
Potential Electrical Hazard.
Do not remove the board enclosure. Depending on your application, you could be exposing yourself to dangerous voltage levels.


To use this unit:

  1. Obtain a Performance Pak (AC244002). This unit can be used only with the Performance Pak.
  2. Use this unit instead of the high-speed receiver board. See the “Performance Pak for the MPLAB® REAL ICE™ In-Circuit Emulator User’s Guide” (DS50002528) for pinouts.
  3. Connect the isolator to one end of the Performance Pak high-speed cables.
  4. Connect the other end of the isolator to the target using an 8-pin, single-line In-Circuit Serial Programming™ (ICSP™) connector.

Figure: High-Speed Emulator System Using Isolator Unit

Isolator_Unit_HW_Setup.jpg

Important Notes:

  1. Target voltage must be at 3.3 V.
  2. When using the isolator, trace is not supported.

  Return to Top

© 2024 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.