Performance Pak LVDS Cables and Target Pinout

The emulator-to-target cable length for a proper operation has been tested for this driver/receiver board combination and is shipped in the Performance Pak. The recommended length is 3 feet (approximately 900 cm), while the maximum is 10 feet (approximately 3 m).

Figure 1: Low Voltage Differential Signaling (LVDS) Cable

LVDSCable.jpg

The target board should have the following 8-pin connection pinout to plug into the receiver board:

Figure 2: 8-Pin Header Pinout at Target

8P_At_Target.jpg

* Optional Trace Clock/Data. See SPI Trace.

  Return to Top

© 2024 Microchip Technology, Inc.
Notice: ARM and Cortex are the registered trademarks of ARM Limited in the EU and other countries.
Information contained on this site regarding device applications and the like is provided only for your convenience and may be superseded by updates. It is your responsibility to ensure that your application meets with your specifications. MICROCHIP MAKES NO REPRESENTATIONS OR WARRANTIES OF ANY KIND WHETHER EXPRESS OR IMPLIED, WRITTEN OR ORAL, STATUTORY OR OTHERWISE, RELATED TO THE INFORMATION, INCLUDING BUT NOT LIMITED TO ITS CONDITION, QUALITY, PERFORMANCE, MERCHANTABILITY OR FITNESS FOR PURPOSE. Microchip disclaims all liability arising from this information and its use. Use of Microchip devices in life support and/or safety applications is entirely at the buyer's risk, and the buyer agrees to defend, indemnify and hold harmless Microchip from any and all damages, claims, suits, or expenses resulting from such use. No licenses are conveyed, implicitly or otherwise, under any Microchip intellectual property rights.